Zenith-data-systems MT2000 Manuel d'utilisateur télécharger pdf (Page 100)

5-12

Upgrades and Options

Pentium Pro Processor

The processor/memory board has two sockets for

Pentium Pro Processors.

Installing a Processor

Figure 5-4 illustrates the location for the optional

Pentium processor in your system. When adding a

second processor, use

the same type and speed as the

processor shipped with your system. Contact your sales

representative.

Notice: Installing a second processor that is of a

different type than the first processor, will result in

system damage. Do not touch or bend the processor's

exposed pins.

The processor upgrade kit contains a DC to DC

converter board, processor chip, and heat sink. The

heat sink has a heat transfer pad on the bottom and

two attached retention clips. To install the second

Pentium Pro processor upgrade kit:

1. Remove the processor/memory board as described

earlier in this section.

Notice: Observe static precautions. Use an antistatic

wrist strap.

Note: Verify that the jumper on the processor/memory

board (see Figure 5-4) is set for the correct processor

speed. Jumper pins 2 and 3 for 200 MHz and pins 1 and

2 for 180 MHz.

2. Raise the lever on the ZIF socket to the up position

(Figure 5-4, A).

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 204 205

Pas de commentaire

Zenith-data-systems MT2000 Manuel d'utilisateur Page 100