Zenith-data-systems MT2000 Manuel d'utilisateur Page 157

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 205
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 156
6-14
Problem Solving
Floppy Disk Drive Activity LED Does Not Light
Check the following:
Are the floppy disk drive power and signal cables
properly installed?
Are all relevant switches and jumpers on the floppy
disk drive set correctly?
Is the floppy disk drive properly configured in
Setup?
If you are using the onboard floppy disk controller, use
Setup or the SCU to make sure that Onboard Floppy is
set to Enabled. Conversely, to use an optional
fixed/floppy disk controller, make sure that Onboard
Floppy is set to Disabled. For information about
running Setup or the SCU, refer to the Configuring
Your System chapter.
If the problem persists, there may be a problem with
the floppy disk drive, system board, or drive signal
cable. Contact your service representative for
assistance.
Vue de la page 156
1 2 ... 152 153 154 155 156 157 158 159 160 161 162 ... 204 205

Commentaires sur ces manuels

Pas de commentaire