Zenith-data-systems MT2000 Manuel d'utilisateur télécharger pdf (Page 48)

3-3

Setup

Making Connections

Note: If your system normally operates without a video

display or keyboard (for example, as a network server),

you must install a video display and keyboard to

configure the system. You may remove them after

running the System Configuration Utility (SCU). For

information on running the SCU, refer to Configuring

Your System in Chapter 4 of this User’s Guide.

Refer to Figure 3-1 and connect your keyboard,

monitor, and mouse. Connect any external peripheral

devices such as a printer or modem by following the

instructions included with these devices. To connect

external SCSI cables, refer to Cabling in Appendix A of

this User’s Guide.

Notice: Damage to the system may result if the

keyboard cable is inserted or removed when power is

applied to the system.

Caution: Inserting a telephone line

connector into a LAN board RJ-45 port

may result in personal injury and

equipment damage.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 204 205

Pas de commentaire

Zenith-data-systems MT2000 Manuel d'utilisateur Page 48